PT Boat Forum


Moderated by: Dick, Jeff D

The PT Boat Forum ª PT Boats of WWII ª  PT Boats - General

« Prev Page | Page: 2 of 2

« Back to Topic Index Page 24 | Replies: 10 | Pages: 1 [2]

 Author  Topic: 3D Printed Model PT Crewmen
Patrick Matthews

New Member
  

    
Post a Reply To This Topic    Reply With Quotes     Edit Message   Posted on: Apr 20, 2016 - 3:45pm
No it's not smooth, that's the nature of these two materials. The white one is laser-sintered nylon powder; the colored one is gypsum-like powder stuck together with little droplets of glue.

There are other materials, about 3 times the cost, which are quite smooth. So maybe $60 for a single 1:16 crewman... a good bit less for smaller scales.

Patrick Matthews
Matthews Model Marine
http://matthewsmodelmarine.wordpress.com/

Total Posts: | Joined: Unregistered | IP Logged

« Prev Page

Pages: 1 [2]


Lock Topic

 

Forum Legend

New Member

Reply to topic

More than 25 posts | Full Member

Reply to topic with quoted message

More than 50 posts | Advanced Member

Edit Message

More than 150 posts | MASTER

View profile

More than 300 posts | TOP BOSS

Email member