PT Boat Forum


Moderated by: Dick, Jeff D

The PT Boat Forum ª PT Boats of WWII ª  PT Boats - General

Page: 1 of 1

« Back to Topic Index Page 13 | Replies: 0

 Author  Topic: Help with HOLDEN8702
Greg Viggiano

New Member
  

    
Post a Reply To This Topic    Reply With Quotes     Edit Message     View Profile of Greg Viggiano  Posted on: Aug 18, 2019 - 4:16am
Luis' model work is excellent and I recently purchased his set of 80' Elco struts, rudders, and props in 1:16 scale for my hull, currently under construction.

Luis was able to redesign the rudder to the Elco 103 specifications and it looks fantastic. After several coats of primer and sanding, all of the 3D build lines are gone and pieces are ready for metal casting.

Unfortunately, after close measurement, the propellers are out of scale for 1:16 and don't measure 30" or 28" like the full scale originals.

I asked Luis if he could redo the propellers in the correct size so I could repurchase at his cost. He understood that to mean at his expense. I was simply asking if it would be possible to not pay the Shapeways designer marker up. Luis is from Spain and spanish is his native language. Apparently, I offended him and he is ignoring my emails clarifying my request.

Are there any other 3D designers on Shapeways that offer an Elco propeller that can be re-sized to 1:16? The finished part should measure about 1.875" - Thanks in advance.

Greg


GV

Total Posts: 14 | Joined: Oct 1, 2012 - 6:36am | IP Logged


Lock Topic

 

Forum Legend

New Member

Reply to topic

More than 25 posts | Full Member

Reply to topic with quoted message

More than 50 posts | Advanced Member

Edit Message

More than 150 posts | MASTER

View profile

More than 300 posts | TOP BOSS

Email member