PT Boat Forum


Moderated by: Dick, Jeff D

The PT Boat Forum ª PT Boats of WWII ª  PT Boats - General

Page: 1 of 1

« Back to Topic Index Page 22 | Replies: 2

 Author  Topic: Holden8702 Elco Rudder, Propeller Shaft, Strut cancelled
  Capt Speirs

Full Member
  

    
Post a Reply To This Topic    Reply With Quotes     Edit Message     View Profile of Capt Speirs  Posted on: May 5, 2017 - 2:29pm
Ordered a number of 3D printings from Shapeways from Holden8702 and all are being made except the Elco Rudder-Propeller-Shaft Strut got cancelled. Trying to get a hold of Luis to let him know, just don't have any contact info and I don't do Facebook. There is no mention in the product description was able to order then the it was cancelled, but everything else went through. Already sent email to Shapeways to see what is happening, just thought Luis should know.


Total Posts: 41 | Joined: Feb 21, 2016 - 6:56pm | IP Logged

Jeff D

Moderator
  

    
Post a Reply To This Topic    Reply With Quotes     Edit Message     View Profile of Jeff D   Send Email To Jeff D Posted on: May 5, 2017 - 4:45pm
I've had that happen, sometimes the techs take a closer look than the automated system does and deems things too fine or delicate to print. The 1/35th hatches I did passed OK but when someone bought the first one I got a message saying the raised "open" lettering was too small... hopefully Luis will be able to fix. I'd guess the sharp edge of a rudder strut or prop is to blame.



Total Posts: 2200 | Joined: Dec 21, 2006 - 1:30am | IP Logged

HOLDEN8702

Full Member
  

    
Post a Reply To This Topic    Reply With Quotes     Edit Message     View Profile of HOLDEN8702  Posted on: May 7, 2017 - 10:52pm
Hi. Luis here.

So sorry about delay to reply in these forums, I didn't take a look on it from two or three days.

Capt, you can contact me through the link available in all my products page, down where read "contact designer" or something else.
I read and reply asap all messages from the three opened shops, facebook or emails. Sometimes, in less than an hour. Send me a message through shapeways internal messenger and I will send you my direct email.

Anyway, the 1/35 propeller, rudder, etc. model is already fixed and open again from some days. It's sad shapeways rejected it, cause they printed this set for the closest 1/32 scale several times without any problem.

Thanks for your interest in my models.

Best regards from the sunny Spain.

Luis


Total Posts: 47 | Joined: Apr 13, 2016 - 1:36am | IP Logged


Lock Topic

 

Forum Legend

New Member

Reply to topic

More than 25 posts | Full Member

Reply to topic with quoted message

More than 50 posts | Advanced Member

Edit Message

More than 150 posts | MASTER

View profile

More than 300 posts | TOP BOSS

Email member