PT Boat Forum


Moderated by: Dick, Jeff D

The PT Boat Forum ª PT Boats of WWII ª  PT Boats - General

Page: 1 of 1

Back to Topic Index Page 30 | Replies: 0

 Author  Topic: Pat's Mk 18 Torpedo Tube parts on Shapeways
Patrick Matthews

New Member
  

    
Post a Reply To This Topic    Reply With Quotes     Edit Message   Posted on: Apr 14, 2016 - 5:56pm
I have built a few Mk 18 torpedo tubes with 3D printed parts from Shapeways, but have hesitated to advertise them. Problem is, my build method makes use of several machined tube segments with joiner rings... it's a labor intensive method, most folks don't have access to a lathe to make the segments, I don't have time to make and offer them, and the 3DP parts add up to quite a bit on top of that.

But I do list the breech door assembly with detonator, as a separate set:
https://www.shapeways.com/product/XEAMK9CWQ/mk18-torp-tube-breech-set-1-20
This is a tricky part to make by hand, so may be useful to some of you. This one is in 1:20... I can scale it to 1:24 and 1:16 or whatever, as needed (though not 1:35 / 1:48!)



Each printed part is a joiner ring between separate tube segments... they would fall apart if bored out to slip over the tube:


Patrick Matthews
Matthews Model Marine
http://matthewsmodelmarine.wordpress.com/

Total Posts: | Joined: Unregistered | IP Logged


Lock Topic

 

Forum Legend

New Member

Reply to topic

More than 25 posts | Full Member

Reply to topic with quoted message

More than 50 posts | Advanced Member

Edit Message

More than 150 posts | MASTER

View profile

More than 300 posts | TOP BOSS

Email member