PT Boat Forum


Moderated by: Dick, Jeff D

The PT Boat Forum ª PT Boats of WWII ª  PT Boats - General

Page: 1 of 1

« Back to Topic Index Page 29 | Replies: 0

 Author  Topic: PT gas caps
TheBridge

TOP BOSS
  

    
Post a Reply To This Topic    Reply With Quotes     Edit Message     View Profile of TheBridge  Posted on: Oct 28, 2015 - 4:18pm
I see many models with PT's (3) gas caps (which are deck mounted) on a high collar. The Italeri does it as well. Yet the PT blue print (reference the Dick Washichek blueprint set file ELCO_Roll_5535-2_72SCAN_00309) in Detail 1 - Deck Fitting Assem. shows the gas cap as nearly flush with the deck surface. The actual dimension is unreadable on the blueprint but is only about 3/16 above the surface of the deck.

Any photo evidence to the contrary of what is in the blueprint or that I'm misreading the blueprint (not likely though)?

Dick: I hope and trust it's OK to use snippets of the blueprint set to show what I am referring to.

Bridge






Total Posts: 315 | Joined: Nov 22, 2009 - 3:04pm | IP Logged


Lock Topic

 

Forum Legend

New Member

Reply to topic

More than 25 posts | Full Member

Reply to topic with quoted message

More than 50 posts | Advanced Member

Edit Message

More than 150 posts | MASTER

View profile

More than 300 posts | TOP BOSS

Email member