PT Boat Forum


Moderated by: Dick, Jeff D

The PT Boat Forum ª PT Boats of WWII ª  PT Boats - General

Page: 1 of 1

« Back to Topic Index Page 69 | Replies: 1

 Author  Topic: Web Site Corrections
Jeff D

Moderator
  

    
Post a Reply To This Topic    Reply With Quotes     Edit Message     View Profile of Jeff D   Send Email To Jeff D Posted on: Nov 24, 2013 - 5:27am
As I was working on the day room cabin trunk, I noticed that I overlooked the connecting duct from the throttle push rod deck housing to the stbd bridge wing supply duct. I also had the position of the duct flange on section 2 of the throttle push rod deck housing wrong, it was too far aft. All the images were updated on the throttle push rod deck housing page, as well as the day room cabin trunk forward view:
http://www.pt103.com/PT_Boat_Components_Throttle_Push_Rod_Deck_Housing.html
http://www.pt103.com/PT_Boat_Components_Day_Room_Cabin_Trunk.html

Of the 103-162 boats that used part of the throttle push rod deck housing as a heater duct, as far as I know only the 139-141 boats (RON 4 Melville training boats) had heaters installed. Please let me know if I'm wrong, thanks.



Total Posts: 2200 | Joined: Dec 21, 2006 - 1:30am | IP Logged

Jeff D

Moderator
  

    
Post a Reply To This Topic    Reply With Quotes     Edit Message     View Profile of Jeff D   Send Email To Jeff D Posted on: Dec 5, 2013 - 9:22am
Oops, I did it again. I had the grab rails a bit too far inboard. All images have been updated and a temporary aft view added. I also found a litter door drawing with a dimensioned cross section of the rain guard (over the windows) and updated them also.



Total Posts: 2200 | Joined: Dec 21, 2006 - 1:30am | IP Logged


Lock Topic

 

Forum Legend

New Member

Reply to topic

More than 25 posts | Full Member

Reply to topic with quoted message

More than 50 posts | Advanced Member

Edit Message

More than 150 posts | MASTER

View profile

More than 300 posts | TOP BOSS

Email member